 |
SYNBOARDTM is, as the name implies, synthetic
board. SYNBOARD is an extruded, celuka process cellular
pvc product with uniform thickness throughout each piece,
and clean, sharp edges. The celuka process gives
SYNBOARD its hard finish which distinguishes it from much of
its competition. The hard, celuka process finish deters
SYNBOARD from being damaged during handling and
installation.
We started marketing SYNBOARD nearly a
decade ago. We bring knowledge and experience with this
specific product category to the table. Let us share
SYNBOARD’s amazing potential with you.
SYNBOARD can be used in place of wood in
virtually any non-stress bearing application. SYNBOARD
is available in both sheet and board stock. SYNBOARD is
produced in a wide range of thicknesses, widths and premium
lengths up to 20 feet. Essentially all of the product is
usable, practically eliminating waste.
SYNBOARD was
introduced as a replacement for trim lumber, and can be used
as casing, soffit, fascia, sills, mouldings, headers, flat
trim, rake boards, frieze boards, and corner boards. SYNBOARD
can be used in transoms, vented louvers, and decorative
columns, but that is only the beginning. Check out our
gallery for just some of the limitless possibilities.
SYNBOARD will not split, warp, cup, rot,
or delaminate like its traditional and engineered
counterparts. SYNBOARD can be used in direct ground or
masonry contact. SYNBOARD is ideal for use in water
damage prone locations such as swimming pool areas or garage
door jambs.
SYNBOARD can be nailed, glued, stapled or
screwed. It can be fastened at the edge without fear of
splitting. It can be easily cut, routed or milled with
conventional woodworking tools. In addition, SYNBOARD
can be heated and shaped to an extraordinary variety of
configurations (see gallery).
Why settle for mediocrity, when the best
doesn’t cost any more?
| |
 |
 |
|